Can laser cleaning be used to clean the surface of a gasket?

Seals are divided into many categories, typically O-ring or skeleton oil seal; these are often used in machinery and equipment seals, and there is a seal is also often used, that is, sealing gasket. Gasket manufacturing material can be made of paper, rubber sheet or copper sheet, placed between two planes to strengthen the sealing ability of the material, in order to prevent leakage to set it between the static sealing surface of the sealing element.

Our company uses laser cleaning equipment to clean the surface of the metal gasket, through the laser beam irradiation, from the metal on the stripping of oil, so as to achieve the role of cleaning, you can see, in the cleaning of the metal before the gasket is covered with stains, after laser cleaning, the surface of the sealing gasket as bright as a new, above the oil, dust and so on have been cleaned up, the metal gasket on the small holes can also be cleaned. The contrast between pre-cleaning and post-cleaning is also very obvious.

Laser cleaning has the following advantages:

1, green cleaning: do not use any chemicals, cleaning waste for the solid harmless powder, can completely solve the environmental pollution problems caused by chemical cleaning.

2,No damage cleaning: non-abrasive cleaning, no contact, no damage to the substrate.

3,Low-cost cleaning: the equipment only consumes a very small amount of electricity when running.

4,Precision and accurate cleaning: can be specified areas for precision and accurate cleaning.

5,Automatic cleaning: it can be matched with automatic equipment to realize automatic cleaning.

With the growing awareness of environmental protection and safety, laser cleaning is widely used because of its non-abrasive, non-contact, non-thermal effect and applicable to a variety of materials and other characteristics of the object. At the same time, laser cleaning can solve the problems that cannot be solved by traditional cleaning methods.